Garage Doors - Questions & Answers

There can be several reasons why a garage door only opens halfway:

1. Obstruction: Check for any obstruction or object that might be blocking the garage door's movement. Sometimes, an object can cause jamming that prevents the door from opening fully.
2. Track or roller issue: Check the garage door tracks for any bends, dents, or damage that can cause the door to come off the track or slow down its movement. Also, the rollers can wear out over time and need replacement.
3. Spring tension: Garage doors operate on spring tension, and if the tension is too high or low, it can create issues with the door's movement. A professional should adjust the spring tension.
4. Motor or opener problems: If the motor or opener is malfunctioning or damaged, it can prevent the door from opening fully.
5. Limit switch issues: The limit switch controls the garage door's opening and closing positions, and if it's misaligned or damaged, it can cause the door to stop midway.

There could be a few possible reasons for this issue. Here are some things to check:

1. Check the battery in the keypad. If the battery is weak or dead, the keypad may not have enough power to send the signal to close the door.
2. Check the wiring connections between the keypad and the garage door opener. If there is a loose or damaged wire, the keypad may not be able to send the signal to close the door.
3. Check the safety sensors. If the safety sensors are misaligned or blocked, the garage door opener may not receive the signal to close the door. Make sure the sensors are clean and free from any obstructions.
4. Check the limit switches. If the limit switches are not set correctly, the garage door opener may not know when to stop closing the door. Adjust the limit switches as needed.

If none of these steps resolve the issue, it may be necessary to consult a professional garage door technician.

Either the battery needs replaced in the remote, or it needs programed. There is a learn button on opener usually yellow you have to push then push button on remote. It should turn light off the learn button and door should open. Hope that was helpful.

I can provide you with some basic troubleshooting steps to turn on a Firegear fireplace:

1. Ensure that the gas supply is on and the tank is filled.
2. Confirm that the pilot light is lit. If not, follow the manufacturer's instructions to relight the pilot light.
3. Check the battery in the remote control to make sure it is not drained.
4. Verify that the power switch on the wall is turned on and the electrical outlet has power.
5. Contact a licensed technician or the manufacturer's customer service for assistance if the above steps do not work and the fireplace still does not turn on.

Note: Please exercise caution while attempting to troubleshoot and always refer to the manufacturer's instructions before attempting any repairs. If you are not comfortable with troubleshooting or repair, always seek professional assistance.